MIG Welding – Argon vs Argon CO2 Mix

Thursday, July 14th, 2016
This article is what I wish I knew before I spent $600 on a Argon Cylinder (Twice). I like to think of it as learning the hard way. Speedshield52 This covers my recent experience with Argon vs Argon Mix for MIG welding and buying two gas cylinders. After about 12months of suffering Gasless MIG wire, inhaling the fumes and cleaning up so much splatter I bit the bullet and bought an Argon cylinder on recommendation of a work colleague. Sadly this didn't quite… Read More

Unimig Inverter 190 – Review

Saturday, July 2nd, 2016
Just over a year ago I bought a Unimig Inverter 190. This is a MMA/MIG/TIG inverter machine with a maximum output of 190A. Unimig 190 This post details some of my personal experiences with the machine, things i like and dislike about it as well as the failures and shortcomings I have found of the machine. It came with all the… Read More

Milling Angle Plates – Part 1

Tuesday, May 31st, 2016
Angle_Plate_SW

Recently we salvaged some nice off cuts of 25 x 200mm flat bar from a scrap bin. We were also in need to some angle plates for use on the CNC mill. Hence started the build of  a matched pair of angle plates for the machine. I will be breaking this post into 3 parts, The fabrication/Welding of the plates in Part 1, Part 2 will be the machinign of the surfaces and Part 3 will be the finishing of the plates including tapping.

… Read More

Two Workshop Upgrades – TIG Stand, Grinding Wheel Rack

Saturday, May 21st, 2016
TIG Helper
When cleaning up my workshop I discovered that I had quite a few small pieces TIG filler laying around, I also had no where to put my TIG torch between welds. This provided a good excuse to do a quick little project out of some scrap.

More pictures after the break.

… Read More
created By ooyes.net